IPB

Welcome Guest ( Log In | Register )

 
Reply to this topicStart new topic
> Can't connect to engine ECU anymore., 145 1.8 Phase1
benedusi
post 6th March 2017 13:10
Post #1 | Print


1.3 8v
*

Group: New Member
Posts: 2
Joined: 22nd January 2017
Local Time: 18th December 2018 16:49
Member No.: 12,989
Driving: 145 1.8 | 164 Super
From: Brazil



Last week, for no reason, the car didn't start, I tried to scan for errors using the VAG-COM and multiecuscan but it won't connect to the engine ECU as it used to, I tried with the ABS ECU and it connects right away.
Couple of hours after I gave up, the car just starts fine with no warning lights, but still no connection with the ECU. So I took the car to the mechanic to see if we could connect with the "real deal" scanner, and nothing.
Any ideas what could be wrong?
Go to the top of the page
View Vehicles
+Quote Post
benedusi
post 20th March 2017 20:06
Post #2 | Print


1.3 8v
*

Group: New Member
Posts: 2
Joined: 22nd January 2017
Local Time: 18th December 2018 16:49
Member No.: 12,989
Driving: 145 1.8 | 164 Super
From: Brazil



Fixed, the floor on the passenger side was wet, probably the humidity had affected the ECU, so, I took it out, cleaned the connector, plug it in again and done.
Also I discovered that the drain holes were filled with dirt, and that caused the water to enter the cabin.
Go to the top of the page
View Vehicles
+Quote Post

Reply to this topicStart new topic

 



- Lo-Fi Version Time is now: 18 Dec 2018 19:49